TALL OUTDOOR WALL FOUNTAIN

Six and a Half Feet That Leans on the Wall

Seventy nine inches of height on a footprint of 31.5 by 23.2 inches, and only 33.3 pounds. Those three numbers only make sense together once you understand what this is. It is not a free standing tower. It is built to sit against a wall or a fence, so the structure behind it is doing the work that mass would otherwise have to do, and that is why it can be this tall without being heavy.

Water sheets down across wide horizontal tiers in a series of curtains, falling from one geometric ledge to the next rather than through spouts or channels. Nine warm white LEDs sit beneath the tiers and light each curtain from below, so after dark you see the water rather than the slate.

The pump and the lights run on separate plugs, so either can operate without the other. Run the lights on a still evening for the glow without the sound, or the water in daylight with the lights off. Plan for two outlets or an outdoor rated power strip.

79 in.Height

33.3 lb.Weight

9 WarmLED Lights

Dual PlugSeparate Control

What Makes This Fountain Different

It needs a wall, and that is the design rather than a limitation. A free standing fountain at this height has to carry enough mass to stay upright on its own, which is why the tall solid pieces here weigh fifty pounds and up. This one leans, so the wall or fence carries the stability and the fountain only has to carry itself. The result is six and a half feet of vertical presence at 33.3 pounds, which two people can position without equipment. Put it in the middle of an open lawn and none of that works, so the wall is not optional.
Water curtains, not streams. Each tier releases water across its full width as a sheet rather than through outlets, so what descends is a series of broad flat falls. On a piece this tall that gives you a lot of visible moving surface, which is the point of the height.
Nine lights, one under each curtain. A single light at the base of a six and a half foot fountain leaves most of it dark. Nine warm white LEDs placed beneath the tiers light each sheet of water from underneath, so the whole height reads after sunset rather than just the bottom.
Independent plugs for pump and lights. Run either without the other, or isolate one for servicing. Uncommon at any price and genuinely useful on a piece you will look at as often as you listen to it.

What the water sounds like

Broad and even rather than sharp. Sheet flow keeps the water in contact with each ledge and releases it across the full width, so there are no individual drops to pick out and no repeating rhythm, just an even wash at several heights. At this scale it has real presence and will soften background noise against a wall, where the hard surface behind it reflects sound forward. How loud it seems will shift with the water level, the wall material, and how enclosed the space is, which is why a fixed decibel number would tell you nothing useful about your own site.

Quick Specifications

Design	Multi tier geometric wall fountain with water curtains
Material	Resin
Finish	Faux dark slate
Dimensions	31.5 in. long, 23.2 in. wide, 79 in. high
Weight	33.3 lb.
Water flow	Sheet flow curtains across horizontal tiers
Lighting	Nine warm white LED lights beneath the tiers
Pump	Included recirculating pump
Controls	Dual independent plugs for pump and lights
Power	AC plug in, 110V
Water connection	Self-contained, no plumbing required
Recommended use	Indoor and outdoor, against a wall

Setup, Care, and Warranty

Placement against a wall

This piece is designed to sit against a wall or fence rather than stand free, and at six and a half feet on 33.3 pounds that is not a styling suggestion. Choose a solid vertical surface behind it and a level solid base underneath, and keep it out of open positions where wind can reach it from every direction.

Plan for two outlets or an outdoor rated power strip, since the pump and the lights have separate plugs. Level it before filling, because sheet flow out of plumb runs heavier on one side of every tier.

Water level and wind

Keep enough water in the reservoir to cover the pump at all times. Sheet flow spread across wide tiers exposes a lot of water to the air, so evaporation is faster than the reservoir size suggests and needs checking every few days in warm weather.

Wind is the other consideration. A sheet of water is easy to blow sideways off a ledge, which costs water and wets whatever is beside it. A sheltered wall position solves both the stability and the drift problem at once.

Cleaning the slate faces

Wipe the wet faces with a soft cloth and keep harsh liquid cleaners off the finish. In hard water areas a pale film builds along the ledge edges where the water releases, and on a dark slate surface it shows sooner than on pale stone. Clean it before it sets rather than after.

Winter storage

Before hard freezes, drain the reservoir and every tier completely, disconnect and store the pump indoors, and dry the piece out. At 33.3 pounds it comes inside without difficulty, and given the height that is easier than covering it in place.

3 year warranty

This product includes a 3 year warranty. Coverage, claim requirements, and required documents are subject to the warranty policy that applies at the time of purchase. Keep your order confirmation, and contact customer support with your order details if service is needed.

Questions Before You Choose

Can it stand on its own in the open?

No, and this is the main thing to plan around. Six and a half feet at 33.3 pounds relies on a wall or fence behind it for stability. In an open position it is vulnerable to wind and to being knocked. If what you need is a free standing tall fountain, choose one of the heavier solid pieces instead.

Why is it so light for its height?

Because it does not have to hold itself up. Free standing tall fountains carry mass specifically for stability, which is why they run fifty pounds and above. A wall mounted design transfers that job to the structure behind it, so the fountain only needs enough material for the water path and the shell. The trade is that it must have a wall.

How is it different from the narrow water wall fountains?

Scale and format. The narrow water walls are around 39 inches and under eight inches deep, built for a strip along a fence. This is twice that height and considerably wider, so it fills a wall rather than fitting beside a path. Same sheet flow principle, very different amount of presence.

Is it safe around children and pets?

At this height and weight it should be positioned against a solid wall and away from the main running route, since it is tall relative to its mass. Run both cords along the wall base so neither catches a foot, and use protected outdoor outlets. Do not let children climb on the tiers. The recirculating water is not intended for drinking.

Resin Geometric Tall Outdoor Wall Fountain 79 Inch LED