Product Description

1

Solder Wick Braid with Flux No-Clean Desoldering Wick Removal Tool, Solder Sucker Wick Roll to Desolder PCB and Remove Solder for Electronics, 5 ft Length, 0.1 inch Width, 2 Pack Wick Main Features: Significantly lessen reworking or repairing time by sucking circuit board solder residue. Protect the fragile components or electronic circuit boards from damages during soldering/reworking/repairing. Quickly and efficiently remove excess solder material while completing hand soldering rework. Removing components that have been soldered to connect to other components, solder bridge removal and general tidying up of solder areas or joints. Fastest wicking action. It is ideal for removing solder from flat surfaces. The components can be reused.

Details Description

1	Quicker wicking: This Solder wick can be used to remove the unwanted excess solder quickly and efficiently during the solder re-working process or remove some already soldered components. The added Flux gives a faster action and helps the surfaces to be heated and solder to flow, which significantly reduces the solder repair time.
2	Copper braids: The braid desoldering wicks are made of 100% copper wires with fine braids woven together, and have good thermal conductivity. Also using the solder braid will protect the delicate components or electronic circuit boards from damages during soldering/reworking/repairing.
3	Wick Application: The desoldering braid wicks are suitable for industry welding, lab work or home work, practical desoldering tools to clean a joint from excess solder and correct mistakes on small PCB boards, the desoldered components can be used again, bringing lots of convenience for your work.
4	Packages include 2 pcs of no-clean solder wicks, each wick is 5 ft in length and 0.1 inch in width.
5	Easy to use: Simply just place the soldering wick against the solder and place heated solder iron tip on it, the soldering wick absorbs the solder due to its high thermal conductivity. By this way, you can remove the solder from the PCB or any metal surface. Leaves slight flux residue that is non-conductive and non-corrosive so it requires no cleaning.